| Customization: | Available |
|---|---|
| After-sales Service: | 1 Year |
| Warranty: | 1 Year |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Drilling Machine |
| Magnetic Drilling Machine |
| Feature |
| The handle lever handle base screw holes screwed before use, tighten, turn the handle, check whether the guides freedom of movement (slide up and down of the new machine will be feeling a little tight). Electrical power, to open the magnetic switch. Open magnet switch, indicator lights, and show that the magnet is in working condition, with iron bars on the magnet at the bottom, check for suction. Open drill switch, to check electric drill normal operation. Note: Move magnetic base, do not drag on the ground, to prevent magnetic damage. |
| Model | W9032 | W9149 |
| Rated voltage | 380V | 380V |
| Rated frequency | 50/60Hz | 50/60Hz |
| Motor input power | 1500W | 2000W |
| No load speed | 150r/min | 110r/min |
| Max. drilling diameter | 32mm | 49mm |
| Max. attraction | 15000N | 26000N |
| Max. travel | 200mm | 200mm |
| Rated axis taper | MT4 | MT4 |
| N.W. | 41.5kg | 42kg |
| Packing size | 49x23x63cm | 49x23x63cm |
| Instruction 1. Use voltage: line voltage does not exceed ±5% of the voltage specified on the nameplate. 2. Use chuck or drill according to the mode of drills. 3. Use the drill bit must be sharp, electric drill for some reason suddenly brake or stuck drill, you must immediately shut down the drill switch (Note: Be sure not to turn off the magnetic base switch). 4. Carbon brush can not be used, to be promptly replaced (two brushes should be replaced at the same time). 5. If magnetic drill failure, should be repaired, and can not be used before the unrepaired. 6. The magnetic drill must be keep clean. |
){kind=link}